Filter
Top Products
Utility Commands
599
ProSafe M4100 and M7100 Managed Switches
The following parameters are displayed in the trace message:
TX/RX
Intf
Src_IP
Dest_IP
Rip_Version
Packet_Type
Routes
Number of
routes not
printed
no debug rip packet
This command disables tracing of RIP requests and responses.
Format no debug rip packet
Mode
debug sflow packet
Use this command to enable sFlow debug packet trace.
Default
Format debug sflow packet
Mode
no debug sflow packet
Use this command to disable sFlow debug packet trace.
Format no debug sflow packet
Mode
Parameter Definition
TX refers to a packet transmitted by the device. RX refers to packets received by the
device.
The interface that the packet came in or went out on. Format used is slot/port (internal
interface number). Unit is always shown as 1 for interfaces on a non-stacking device.
The source IP address in the IP header of the packet.
The destination IP address in the IP header of the packet.
RIP version used <RIPv1 or RIPv2>.
Type of RIP packet. <RIP_REQUEST or RIP_RESPONSE>.
Up to 5 routes in the packet are displayed in the following format:
Network: <a.b.c.d> Mask <a.b.c.d> Next_Hop <a.b.c.d> Metric <a>
The next hop is only displayed if it is dif
ferent from 0.0.0.0.
For RIPv1 packets, Mask is always 0.0.0.0.
Only the first five routes present in the packet are included in the trace. There is another
notification of the number of additional routes present in the packet that were not
included in the trace.
Privileged EXEC
disabled
Privileged EXEC
Privileged EXEC