Filter
Top Products
Routing Commands
282
ProSafe M4100 and M7100 Managed Switches
ip ospf mtu-ignore
This command disables OSPF maximum transmission unit (MTU) mismatch detection. OSPF
Database Description packets specify the size of the largest IP packet that can be sent
without fragmentation on the interface. When a router receives a Database Description
packet, it examines the MTU advertised by the neighbor. By default, if the MTU is larger than
the router can accept, the Database Description packet is rejected and the OSPF adjacency
is not established.
Default
Format ip ospf mtu-ignore
Mode
no ip ospf mtu-ignore
This command enables the OSPF MTU mismatch detection.
Format no ip ospf mtu-ignore
Mode
router-id (OSPF)
This command sets a 4-digit dotted-decimal number uniquely identifying the router ospf id.
The <ipaddress> is a configured value.
Format router-id <ipaddress>
Mode
redistribute (OSPF)
This command configures OSPF protocol to allow redistribution of routes from the specified
source protocol/routers.
Default
• metric—unspecified
• type—2
• tag—0
Format redistribute {rip | static | connected} [metric <0-16777214>]
[metric-type {1 | 2}] [tag <0-4294967295>] [subnets]
Mode
enabled
Interface Config
Interface Config
Router OSPF Config
Router OSPF Config