Filter
Top Products
Management Commands
674
ProSafe M4100 and M7100 Managed Switches
no snmp-server enable traps
Use this command to disable the Authentication Flag.
Format no snmp-server enable traps
Mode
Note: This command might not be available on all platforms.
snmp-server enable traps linkmode
Use this command to enable Link Up/Down traps for the entire switch. When enabled, link
traps are sent only if the Link Trap flag setting associated with the port is enabled. For more
information, see snmp trap link-status on page 677
Default
Format snmp-server enable traps linkmode
Mode
no snmp-server enable traps linkmode
Use this command to disable Link Up/Down traps for the entire switch.
Format no snmp-server enable traps linkmode
Mode
snmp-server enable traps multiusers
Use this command to enable Multiple User traps. When the traps are enabled, a Multiple
User Trap is sent when a user logs in to the terminal interface (EIA 232 or Telnet) and there
is an existing terminal interface session.
Default
Format snmp-server enable traps multiusers
Mode
Format snmp-server enable traps
Mode
Global Config
Global Config
enabled
Global Config
Global Config
enabled
Global Config