Filter
Top Products
Utility Commands
604
ProSafe M4100 and M7100 Managed Switches
cablestatus
This command returns the status of the specified port.
Format cablestatus <slot/port>
Mode
sFlow Commands
sFlow
®
is the standard for monitoring high-speed switched and routed networks. sFlow
technology is built into network equipment and gives complete visibility into network activity,
enabling effective management and control of network resources.
sflow receiver
Use this command to configure the sFlow collector parameters (owner string, receiver
timeout, max datagram size, IP address, and port).
Format sflow receiver <rcvr_idx> owner <owner-string> [timeout
<rcvr_timeout> | notimeout] max datagram <size> ip/ipv6 <ip> port
<port>
Mode
Privileged EXEC
Field Description
Cable Status
One of the following statuses is returned:
• Normal: The cable is working correctly.
• Open: The cable is disconnected or there is a faulty connector.
• Short: There is an electrical short in the cable.
• Cable Test Failed: The cable status could not be determined. The cable may in fact
be working.
Cable Length
If this feature is supported by the PHY for the current link speed, the cable length is
displayed as a range between the shortest estimated length and the longest estimated
length. Note that if the link is down and a cable is attached to a 10/100 Ethernet adapter,
then the cable status may display as Open or Short because some Ethernet adapters
leave unused wire pairs unterminated or grounded. Unknown is displayed if the cable
length could not be determined.
Global Config