Filter
Top Products
Switching Commands
122
ProSafe M4100 and M7100 Managed Switches
no monitor session
Use this command without optional parameters to remove the monitor session (port
monitoring) designation from the source probe port, the destination monitored port and all
VLANs. Once the port is removed from the VLAN, you must manually add the port to any
desired VLANs. Use the source interface <slot/port> parameter or destination
interface <slot/port> to remove the specified interface from the port monitoring
session. Use the mode parameter to disable the administrative mode of the session
Note: Since the current version of 7000 series software supports only one
session, if you do not supply optional parameters, the behavior of
this command is similar to the behavior of the no monitor
command.
no monitor
This command removes all the source ports and a destination port for the and restores the
default value for mirroring session mode for all the configured sessions.
Note: This is a stand-alone “no” command. This command does not have
a “normal” form.
show monitor session
This command displays the Port monitoring information for a particular mirroring session.
Note: The <session-id> parameter is an integer value used to identify
the session. In the current version of the software, the
<session-id> parameter is always one (1)
Format no monitor session <session-id> [{source interface <slot/port> |
destination interface <slot/port> | mode}]
Mode
Global Config
Default
enabled
Format no monitor
Mode
Global Config