Filter
Top Products
Utility Commands
529
ProSafe M4100 and M7100 Managed Switches
falling utilization threshold is optional. If the falling CPU utilization parameters are not
configured, they take the same value as the rising CPU utilization parameters.
Format
process cpu threshold type total rising <1-100> interval
<5-86400> {falling <1-100> interval <5-86400>}
Mode
show process cpu
This command provides the percentage utilization of the CPU by different tasks.
Note: It is not necessarily the traffic to the CPU, but different tasks that
keep the CPU busy.
The following shows example CLI display output.
(Switch) #show process cpu
Memory Utilization Report
status bytes
------ ----------
free 192980480
alloc 53409968
Task Utilization Report
Task Utilization
----------------------- -----------
bcmL2X.0 0.75%
Global Config
Parameter Description
rising threshold The percentage of CPU resources that, when exceeded for the configured rising interval,
triggers a notification. The range is 1–100. The default is 0 (disabled).
rising interval The duration of the CPU rising threshold violation, in seconds, that must be met to trigger a
notification. The range is 5–86,400. The default is 0 (disabled).
falling threshold The percentage of CPU resources that, when usage falls below this level for the configured
interval, triggers a notification. The range is 1–100. The default is 0 (disabled). A notification is
triggered when the total CPU utilization falls below this level for a configured period of time.
The falling utilization threshold notification is made only if a rising threshold notification was
previously done. The falling utilization threshold must always be equal or less than the rising
threshold value. The CLI does not allow setting the falling threshold to be greater than the
rising threshold.
falling interval The duration of the CPU falling threshold, in seconds, that must be met to trigger a
notification. The range is 5–86,400. The default is 0 (disabled).
Format show process cpu
Mode
Privileged EXEC