Filter
Top Products
Quality of Service (QoS) Commands
475
ProSafe M4100 and M7100 Managed Switches
ibmsna, ipv4, ipv6, ipx, mplsmcast, mplsucast, netbios, novell, pppoe, rarp. Each of these
translates into its equivalent Ethertype value(s).
The time-range parameter allows imposing time limitation on the MAC ACL rule as
defined by the parameter <time-range-name>. If a time range with the specified namedoes
not exist and the MAC ACL containing this ACL rule is applied to an interface orbound to a
VLAN, then the ACL rule is applied immediately. If a time range withspecified name exists
and the MAC ACL containing this ACL rule is applied to aninterface or bound to a VLAN, then
the ACL rule is applied when the time-range withspecified name becomes active. The ACL
rule is removed when the time-range withspecified name becomes inactive.
The vlan and cos parameters refer to the VLAN identifier and 802.1p user priority fields,
respectively, of the VLAN tag. For packets containing a double VLAN tag, this is the first (or
outer) tag.
The assign-queue parameter allows specification of a particular hardware queue for handling
traffic that matches this rule. The allowed <queue-id> value is 0-(n-1), where n is the
number of user configurable queues available for the hardware platform. The
assign-queue parameter is valid only for a permit rule.
Note: The special command form {deny | permit} any any is used to match
all Ethernet layer 2 packets, and is the equivalent of the IP access
list “match every” rule.
Ethertype Keyword Corresponding Value
appletalk 0x809B
arp 0x0806
ibmsna 0x80D5
ipv4 0x0800
ipv6 0x86DD
ipx 0x8037
mplsmcast 0x8848
mplsucast 0x8847
netbios 0x8191
novell 0x8137, 0x8138
pppoe 0x8863, 0x8864
rarp 0x8035