Filter
Top Products
Quality of Service (QoS) Commands
470
ProSafe M4100 and M7100 Managed Switches
The following information is repeated for each class associated with this policy (only the
policy attributes that are configured are displayed):
Term Definition
Assign Queue
Directs traffic stream to the specified QoS queue. This allows a traffic classifier to specify
which one of the supported hardware queues are used for handling packets belonging to
the class.
Class Name
The name of this class.
Committed
Burst Size (KB)
The committed burst size, used in simple policing.
Committed Rate
(Kbps)
The committed rate, used in simple policing,
Conform Action
The current setting for the action taken on a packet considered to conform to the policing
parameters. This is not displayed if policing is not in use for the class under this policy.
Conform COS
The CoS mark value if the conform action is set-cos-transmit.
Conform DSCP
Value
The DSCP mark value if the conform action is set-dscp-transmit.
Conform IP
Precedence
Value
The IP Precedence mark value if the conform action is set-prec-transmit.
Drop
Drop a packet upon arrival. This is useful for emulating access control list operation
using DiffServ, especially when DiffServ and ACL cannot co-exist on the same interface.
Mark CoS
The Class of Service value that is set in the 802.1p header of inbound packets. This is
not displayed if the mark cos was not specified.
Mark IP DSCP
The mark/re-mark value used as the DSCP for traffic matching this class. This is not
displayed if mark ip description is not specified.
Mark IP
Precedence
The mark/re-mark value used as the IP Precedence for traffic matching this class. This is
not displayed if mark ip precedence is not specified.
Mirror
Copies a classified traffic stream to a specified egress port (physical port or LAG). This
can occur in addition to any marking or policing action. It might also be specified along
with a QoS queue assignment.
Non-Conform
Action
The current setting for the action taken on a packet considered to not conform to the
policing parameters. This is not displayed if policing not in use for the class under this
policy.
Non-Conform
COS
The CoS mark value if the non-conform action is set-cos-transmit.
Non-Conform
DSCP Value
The DSCP mark value if the non-conform action is set-dscp-transmit.
Non-Conform IP
Precedence
Value
The IP Precedence mark value if the non-conform action is set-prec-transmit.