Filter
Top Products
Switching Commands
173
ProSafe M4100 and M7100 Managed Switches
no port-security max-static
This command sets maximum number of statically locked MAC addresses to the default
value.
Format no port-security max-static
Mode
port-security mac-address
This command adds a MAC address to the list of statically locked MAC addresses. The
<vid> is the VLAN ID.
Format port-security mac-address <mac-address> <vid>
Mode
no port-security mac-address
This command removes a MAC address from the list of statically locked MAC addresses.
Format no port-security mac-address <mac-address> <vid>
Mode
port-security mac-address move
This command converts dynamically locked MAC addresses to statically locked addresses.
Format port-security mac-address move
Mode
port-security mac-address sticky
This command enables sticky mode Port MAC Locking on a port. If accompanied by a MAC
address and a VLAN id (for interface config mode only), it adds a sticky MAC address to the
list of statically locked MAC addresses. These sticky addresses are converted back to
dynamically locked addresses if sticky mode is disabled on the port. The <vid> is the VLAN
ID. The Global command applies the sticky mode to all valid interfaces (physical and LAG).
There is no global sticky mode as such.
Sticky addresses that are dynamically learned will appear in show running config as
port-security mac-address sticky <mac> <vid> entries.
This distinguishes them
from static entries.
Format
port-security mac-address sticky [<mac-address> <vid>]
Modes
• Global Config
• Interface Config
Interface Config
Interface Config
Interface Config
Interface Config