Filter
Top Products
Routing Commands
273
ProSafe M4100 and M7100 Managed Switches
bandwidth
By default, OSPF computes the link cost of an interface as the ratio of the reference
bandwidth to the interface bandwidth. Reference bandwidth is specified with the auto-cost
command. For the OSPF link cost calculation, use the bandwidth command to specify the
interface bandwidth. The bandwidth is specified in kilobits per second. If no bandwidth is
configured, the bandwidth defaults to the actual interface bandwidth for port-based routing
interfaces and to 10 Mbps for VLAN routing interfaces. This command does not affect the
actual speed of an interface.
Default
Format bandwidth <1-10000000>
Mode
no bandwidth
Use this command to set the interface bandwidth to its default value.
Format no bandwidth
Mode
capability opaque
Use this command to enable Opaque Capability on the Router. The information contained in
Opaque LSAs might be used directly by OSPF or indirectly by an application wishing to
distribute information throughout the OSPF domain. The 7000 series supports the storing
and flooding of Opaque LSAs of different scopes.
Default
Format capability opaque
Mode
no capability opaque
Use this command to disable opaque capability on the router.
Format no capability opaque
Mode
clear ip ospf
Use this command to disable and reenable OSPF.
Format clear ip ospf
Mode
actual interface bandwidth
Interface Config
Interface Config
disabled
Router OSPF Config
Router OSPF Config
Privileged EXEC