Filter
Top Products
Quality of Service (QoS) Commands
496
ProSafe M4100 and M7100 Managed Switches
also choose to use these {unreserved} ports).
When a port is already defined and not bound to an IP, and the User
wants to bind it to an IP
, the User should first remove it by using the
no form of the command and then add it again, this time together
with the relevant IP.
Target names are only for display when using show iscsi command.
These names are not use to match (or for doing any sanity check)
with the iSCSI session information acquired by snooping.
Maximum of 16 TCP ports can be configured either bound to IP or
not.
Format iscsi target port tcp-port-1 [tcp-port-2.… tcp-port-8] [address
ip-address] [name targetname]
Mode
Default
tcp-port
ip-address
targetname
no iscsi target port
This command is to delete iSCSI port/s, target, use the no form of this command.
Format no iscsi target port tcp-port-1 [tcp-port-2.… tcp-port-8] [address
ip-address]
Mode
iscsi cos
The iscsi cos Global Configuration mode command sets the Quality of Service profile that will
be applied to iSCSI flows.
Global Config
3260 and 860, but they can be removed as any other configured target
Term Definition
TCP port number or list of TCP port numbers on which iSCSI target/s listen to
requests. Up to 16 TCP ports can be defined in the system in one command or by
using multiple commands.
IP address of the iSCSI target. When the no form is used, and the tcp port to be
deleted is one bound to a specific IP address, the address field must be present.
iSCSI name of the iSCSI target. The name can be statically configured; however, it can
be obtained from iSNS or from sendT
argets response. The initiator must present both
its iSCSI Initiator Name and the iSCSI Target Name to which it wishes to connect in the
first login request of a new session or connection.
Global Config