Filter
Top Products
ProSafe Dual Band Wireless-N Access Point WNDAP350 Reference Manual
2-6 Basic Installation and Configuration
v1.1, November 2009
4. Access Point Name: Enter the access point name of the WNDAP350.
This unique name is the access point NetBIOS name. The default Access Point Name is
located on the bottom label of WNDAP350. The default is netgearxxxxxx, where xxxxxx
represents the last 6 digits of the WNDAP350 MAC address. You may modify the default
name with a unique name up to 15 characters long.
5. From the Country/Region pull-down menu, select the region where the WNDAP350 can be
used (the default Country/Region is the United States).
6. Spanning Tree Protocol. Enable or disable spanning tree protocol. Spanning tree protocol
enables network traffic optimization in settings with multiple WNDAP350 wirelss access
points. The default is Disable.
7. 802.1Q VLAN. This section allows each Security Profile to be associated with the default
VLAN for WNDAP350. (Useful primarily if the hubs/switches on your LAN support the
VLAN 802.1Q standard.)
Figure 2-3 Access Point Name and Country / Region
Note: If your country or region is not listed, please check with Netgear Support.