Filter
Top Products
3 Configuration commands Security commands
NN47928-107 115
Security NAT public
A public IP address must be configured for static NAT and also for address
forwarding. This command adds public IP addresses to NAT. Up to 16
addresses can be configured. NAT addresses can be configured outside the
subnet of the WAN.
Syntax config security nat public <address> interface <type>
Parameters address Enter the public IP address. This can be a
single IP address or a range of address using
the xx.xx.xx.xx—xx.xx.xx.xx format.
interface type Select the interface type. The BSGX4e BG
supports eth0 and none. The default is none.
Select none if the public address you entered is
within the subnet range of the WAN. If you are
creating a public address outside of the existing
WAN subnet, select the WAN interface to which
it applies.
Example > config security nat public 192.168.134.199
Related
commands
del security nat public
display security nat public
show security nat public