Filter
Top Products
3 Configuration commands Media gateway controller protocol commands
NN47928-107 73
mgcp sc settings
All VoIP traffic is directed through the session controller, allowing it to
isolate and control all VoIP devices on the internal network (LAN). Use this
command to configure the session controller settings.
Syntax config mgcp sc settings server <name> wanrxport <number>
lanrxport <number> keepalive <seconds> eptimeout <seconds>
maxcalls <number> sigqos <name>
Parameters name Enter the name of the MGCP call server profile.
To see the configured server profiles, enter
show mgcp server settings.
wanrxport number Enter the port on which to listen for MGCP
signaling messages from the WAN. The default
is 2427.
lanrxport number Enter the port on which to listen for MGCP
signaling messages from the LAN. The default
is 2427.
keepalive seconds Interval between keep-alive messages sent to
the MGCP server. Specify zero (0) to disable the
sending of keep-alive messages. The default is
0.
eptimeout seconds Endpoint timeout interval. The default is 3600
seconds (one hour).
maxcalls number The maximum number of calls for the BSGX4e
is 250.
siqqos name Enter the name of the GoS quality group that
specifies the QoS protection for MGCP signaling
traffic. To see the configured quality groups,
enter show qos group.
Example > config mgcp sc settings server Sylantro wanrxport 2427
lanrxport 2427 sigqos VoIP
Related
commands
display mgcp sc settings
show mgcp sc setting
show mgcp sc endpoints
clear mgcp sc calls
show mgcp sc calls
stats mgcp sc calls
clear mgcp sc status
show mgcp sc status
stats mgcp sc status
show qos group