Filter
Top Products
3 Configuration commands Radius commands
NN47928-107 97
Enter the binding IP address for the client. It is
the IP address of the interface that the server
references (typically, the IP address of the WAN
interface.) Specify this value only if DHCP is not
in use.
interface eth0|eth1|none
Select the physical interface through which
RADIUS communicates if the auto parameter
is yes. This is typically the WAN interface. To
clear the parameter, specify none.
Example > config radius client RadiusUser
Entering interactive mode: ctrl^z | 'exit', ctrl^c | 'quit'
TAB to cycle parameter options
radius-cl-Radi#> enabled yes
radius-cl-Radi#> auto yes
radius-cl-Radi#> authserver radius.wan.com
radius-cl-Radi#> secret Radsecret
radius-cl-Radi#> interface eth0
radius-cl-Radi#> exit
Related
commands
del radius client
display radius client
show radius client
show user accounts