Filter
Top Products
SIP commands 3 Configuration commands
132 NN47928-107
SIP UA settings
Use this command to configure the SIP protocol settings on a BSGX4e that
apply to the SIP user agent. The SIP settings for the gateway do not apply to
the SIP session controller.
The SIP protocol can be modified for interoperability purposes within the
SIP environment.
Syntax config sip ua settings timert1 <ms> timert2 <ms> timerb <ms>
regexpire <seconds> seenable [yes|no] setimer <seconds>
minsetimer <seconds> onholdtimer <seconds> noanstimer
<seconds> endofdial [yes|no] interdigittimeout <seconds>
Parameters timert1 ms Set the SIP retransmission T1 interval. The
default is 500 milliseconds.
timert2 ms Set the SIP retransmission T2 interval. The
default is 4000 milliseconds.
timerb ms Set the SIP retransmission B interval. The
default is 32000 milliseconds.
regexpire seconds Set the timeout interval for expiration of the
endpoint registration. The default is 3600
seconds (1 hour).
seenable yes|no Enable/disable session-expires support (see
setimer and minsetimer). The default is no
(disabled).
setimer seconds Enter the maximum session interval if no
session refresh requests are received. If the
timer expires, the session ends. The default is
1800 seconds (30 minutes). This parameter is
valid only if seenable is yes.
minsetimer seconds
Enter the minimum session interval that the
User Agent can accept. The default is 90
seconds. This parameter is valid only if
seenable is yes.
onholdtimer seconds
Enter the maximum interval of time in seconds
that the User Agent can be put on hold with no
audio or music-on-hold. If the on hold timer
expires, the call is disconnected. The default is
180 seconds (3 minutes).
noanstimer seconds