Filter
Top Products
3 Configuration commands SNMP commands
NN47928-107 137
snmp traps
Use this command to configure SNMP traps. The following traps are
supported:
z ColdStart: indicates the BSGX4e has restarted.
z WarmStart: indicates the SNMP agent has restarted.
z LinkUp: indicates an interface has come up.
z LinkDown: indicates an interface has gone down.
z AuthenticationFail: indicates SNMP authentication has failed (such
as when the wrong community name is used).
Syntax config snmp traps enabled [yes|no] comm <community> ip <ip
address>
Parameters enabled yes|no Enable or disable the SNMP traps.
comm community Enter the traps community
ip ip address Enter the IP address of the management station
receiving the traps.
Example > config snmp traps enabled yes comm public ip 192.168.134.161
Related
commands
display snmp traps
show snmp traps
clear snmp agent
stats snmp agent