Filter
Top Products
3 Configuration commands Local call routing commands
NN47928-107 63
lcr settings
Use this command to configure local call routing settings, including if a
gateway is used for external calls, the emergency call number, and the
numbering plan settings that allow the BSGX4e to determine if the call is
local or external.
Syntax config lcr settings lcbmode [int|lgw] ecpolice <value> ecfire
<value> ecambulance <value> ecmisc <value> obaccess <value>
areacode <value> coprefix <value> enlength <value> ectofxo
[yes|no]
NOTE: For this release, the parameters ecpolice, ecfire, ecambulance,
and ecmisc are automatically set by the country code configured using
system info on page 160
Parameters lcbmode int|lgw Enter the local call backup mode (int for the
Integrated Gateway or lgw for a SIP/PSTN
gateway on the LAN). Only one gateway can be
configured. The default is int.
ecpolice value Enter the emergency call number of the police
station. The default is 911.
ecfire value Enter the emergency call number of the fire
station. The default is 911.
ecambulance value Enter the emergency call number of the
ambulance service. The default is 911.
ecmisc value Enter another emergency call number. The
default is 911.
obaccess value Enter the outbound access prefix digit (such as
9 to place an outside call, as in 9-555-1212).
Applies only to hosted PBX service. The default
is 9.
areacode value Enter a valid area code, for example, enter 408
for the phone number 408-555-5555.
coprefix value Enter a valid Central Office prefix, for example,
enter 555 for the phone number 408-555-5555.
enlength value Enlength is the length of the extensions used to
place local calls (not the full phone number).
For example the extension of the full phone
number 408-555-1234 is 1234 if this
parameter is 4. It is 234 if this parameter is 3.
The default is 4 digits.
ectofxo yes|no Specify to force the emergency call (ecnumber)
to be routed through the FXO port or gateway
in normal mode, for example not in survival
mode. The default is yes.
Example Use this command to allow an emergency call for the police station (911) to
be routed through the FXO port in a scenario where the BSGX4e is behind
a PBX and needs a 9 to dial out.