Filter
Top Products
68 User’s Guide
15:USER LANGUAGE:
This function allows you to switch between the
two languages programmed into your fax machine.
16:INCOMING RING:
This function controls the telephone ringing
sound your fax machine makes when a call comes in. Available settings
are on and off.
17:REMOTE RECEIVE:
When you receive an incoming call, this
function allows you to remotely tell your fax machine to switch from
telephone to fax mode to receive an incoming fax. To use this function, use
the keypad of a handset or an external telephone to enter the remote receive
number you have programmed into your fax machine. Available settings
are off, 00, 11, 22, 33, 44, 55, 66, 77, 88, 99, ** and ##. This function only
works if your telephone system is a tone dialling system.
18:MEM./FEEDER SW.:
This function controls how your fax machine
normally transmits fax messages to one location. Either scanning the
document into memory first and then start dialling, or by transmitting
directly from the document feeder after dialling. Available settings are
MEM. and FEED.
19:POWER SAVE MODE:
This function substantially reduces the
amount of power your fax machine consumes when it is not in use. When
this function is on, your fax machine automatically switches to power save
mode after it has been idle for three minutes. When this occurs, your
display shows: POWER SAVE MODE, PRESS“START” TO EXIT.
While in this mode, your fax machine automatically switches back to full
operation after you press the Start key, when the telephone rings, when the
telephone handset is lifted, or when a document is loaded. Available
settings are on and off.
20:ECM FUNCTION:
The error correction mode function helps your fax
machine to improve communication in areas where telephone line
conditions are poor. Available settings are on and off.
Note:
When using ECM, the transmitting fax machine
automatically checks the data as it is sent. If the
receiving fax machine cannot verify the
transmission, the transmitting fax machine will
retransmit as necessary. Using ECM also increases
transmission time because the data is checked as it is
transmitted.