72 User’s Guide
Service function settings
Service function settings in many cases greatly change the way your fax
machine operates. To change any of these settings, contact your dealer.
Service function settings list
LONG DOC. STX:
Normally, your fax machine will not scan documents
longer than 360 mm. When this function is on, your fax machine will scan
and transmit documents of any length for up to one hour.
MDY/DMY:
This function controls how your fax machine displays and
prints the date (month / day / year or day / month / year).
TIME/DATE PRINT:
This function controls how the time and date are
printed on the fax messages which you transmit. Your fax machine can be
set to not print the time and date, to print it at the top the first page only, or
to print it at the top of every page.
TSI PRINT:
When this function is on, the telephone number of the fax
machine sending you a fax message is printed at the top of each page of
the message.
NO TONER MEM. RX:
When this function is turned on, your fax
machine automatically receives messages in memory when it is low on
toner.
TAD MODE:
This function allows an answering machine to operate on
the same line as your fax machine.
TEL/FAX SW.:
When this function is on, the telephone/fax [T/F]
answering mode is available, which allows your fax machine to
automatically distinguish between incoming voice and fax telephone calls.
MONITOR CONT.:
This function controls the line monitoring sounds
you hear while your fax machine is dialling and all fax communication
sounds. Available settings are on and off.
REAL TIME DIAL:
This function controls how you can dial telephone
numbers on your fax machine. Normally, your fax machine waits for you
to enter an entire telephone number and press Start before dialling. When
this function is set to type 1, you can dial immediately (digit by digit)
whenever you pick up the handset. When this function is set to type 2, you
can dial immediately whenever you pick up the handset or press the Hook
key. Available settings are off, type 1 and type 2.