Filter
Top Products
41
Use the following procedure to wire connectors.
Refer to the following diagrams as necessary.
1. Cut the cable to the required length.
2. Being careful not to damage the braiding underneath, use a razor blade
to cut away 25 mm of sheath.
3. Using scissors, cut away all but 10 mm of the exposed shield wire braid-
ing.
4. Using wire strippers, remove the covering from the last 5 mm of all
wires.
5. Fold the braiding back over the end of the sheath.
6. Wrap aluminum foil tape 1 1/2 turns over top of the braiding on top of
the sheath.
5 mm
10 mm
Aluminum foil tape
25 mm
Refer to the following diagrams as necessary.
1. Cut the cable to the required length.
2. Being careful not to damage the braiding underneath, use a razor blade
to cut away 25 mm of sheath.
3. Using scissors, cut away all of the exposed shield wire braiding.
4. Using wire strippers, remove the covering from the last 5 mm of all
wires.
5. Wrap electrician’s tape over top of the end of the cut sheath.
25 mm
Electrician’s
tape
5 mm
Wiring Cables
Preparing to Connect
Shield Wire to FG
1, 2, 3...
Preparing for No Shield
Wire Connection to FG
1, 2, 3...
Mounting and Connections Section 5-1