Filter
Top Products
Equipment Installation
(.. /continued)
Installing the TRIMAR Radio
Figure 3: Bracket assembly details
RECOMMENDATIONS: 1. Do not mount the radio upside down or sideways. The
type N-connector must face downwards towards the ground.
2. Strap down the external CAT 5 cable leading from the radio to
the antenna mast or other suitable fixture.
HOW TO RESET THE RADIO TO FACTORY
DEFAULTS:
Should it become necessary to do a hardware reset of
the TRIMAR AP to factory default settings, follow the
steps below. Refer to Figure 3 for the location of the
reset button:
1. Unscrew and remove the cable cover and
gently
pull assembly away from the main case.
2. To reset the unit the radio needs to be
powered.
3. Press firmly on the reset button and watch the
indication of the LED lamps.
4. When the reset is successfully performed, the
LED lamps will dim and then light up again as
the unit reboots.
5. After resetting, reconnect the CAT 5 cable and
replace the cable cover taking care to ensure
that this is replaced correctly to avoid
moisture from getting into the unit.
DO NOT UNDER ANY CIRCUMSTANCE OPEN THE PRIMARY
CASE OF THE RADIO. DOING SO WILL BREAK THE SPECIAL
WEATHER SEAL BETWEEN THE CASE COVER AND MAIN
CASING AND WILL AUTOMATICALLY VOID THE WARRANTY
ON THE UNIT.
THERE ARE NO USER SERVICABLE PARTS INSIDE THE CASE.
WARNING:
After fixing and testing the radio at its final
location, use the weather sealant provided to protect
the antenna and N-connector from the elements. Failure
to do so could cause water to corrode the connection or allow
water seepage to penetrate the weather casing and causing
catastrophic damage to the radio circuitry.
PEGASUS WIRELESS CORPORATION TRIMAR TECHNICAL MANUAL Version 1.0 Page 6 of 32