Filter
Top Products
- 160 -
Others
[Insert SD card again]/[Try another card]
•
An error has occurred accessing the card.
> Insert the card again.
> Insert a different card.
[Read Error/Write Error
Please check the card]
•
It has failed to read or write data.
> Remove the card after turning this unit off. Insert the card again, turn this unit on, and try to
read or write the data again.
•The card may be broken.
> Insert a different card.
[Motion recording was cancelled due to the limitation of the writing speed of the card]
•
Use a card with SD Speed Class with “Class 4” or higher when recording motion pictures.
•In the event that it stops even after using a “Class 4” card or higher, the data writing speed has
deteriorated so it is recommended to make a backup and then format (P49).
•Depending on the type of the card, motion picture recording may stop in the middle.
[Cannot record due to incompatible format(NTSC/PAL) data on this card.]
> Format the card after saving necessary data on a PC etc. (P49)
> Insert a different card.
[A folder cannot be created]
•
A folder cannot be created because there are no remaining folder numbers that can be used.
> Format the card after saving necessary data on a PC etc. (P49)
[Picture is displayed for 16:9 TV]/[Picture is displayed for 4:3 TV]
•
Select [TVAspect] in the [Setup] menu if you want to change the TV aspect. (P48)
•This message also appears when the USB connection cable is connected to the camera only.
In this case, connect the other end of the USB connection cable to a PC or a printer. (P140, 146)
[This battery cannot be used]
•
Use a genuine Panasonic battery. If this message is displayed even when a genuine Panasonic
battery is used, contact the dealer or your nearest Service Centre.
•If the battery terminal is dirty, clean it and remove any objects.
[Failed to connect wireless access point]/[Connection failed]/[No destination found]
•Check following regarding the wireless access point.
> The wireless access point information set on this unit is wrong. Check the authentication type,
encryption type, and encryption key. (P127)
> Power of the wireless access point is not turned on.
> Setting of the wireless access point is not supported by this unit.
•Check the network setting of the destination.
•Radio waves from other devices may block the connection to a wireless access point. Check other
devices that are connected to the wireless access point and devices that use the 2.4 GHz band.