- 171 -
Others
•Upload may not complete when it is disconnected while transmitting the image.
•It may take some time after uploading the image to be reflected in the WEB service depending on
the status of the server.
> Wait for a while and try again.
•Transmission status can be checked in WEB destination settings by logging into the “LUMIX CLUB”.
•The images in the WEB Service cannot be saved (downloaded) to this unit. Do not delete the
uploaded images, and make a backup of them.
• The images uploaded to the WEB service cannot be displayed or deleted by this unit.
> Perform the task using a smartphone or a PC.
•The settings stored in the camera may be deleted depending on the type of repair.
> Always make a copy of important settings.
•Is the size of the image too large?
> Divide the motion picture using [Video Divide] (P97).
> Reduce the size of the still picture at [Size] in [Send Image] or [Size] in [Smart Transfer], then
transmit (P118, 123).
•Capacity or number of images in the WEB service is full.
> Login to the “LUMIX CLUB”, and check the status of the destination by WEB destination settings.
> Execute the [Reset Wi-Fi Settings] in the [Setup] menu. (P48)
> However, all the information set with the [Wi-Fi Setup] menu, such as the wireless access point,
login setting of the “LUMIX CLUB”, etc., will also be reset.
• Is the size of the image too large?
> Reduce the size of the still picture at [Size] in [Send Image] or [Size] in [Smart Transfer], then
transmit (P118, 123).
> Transmit after dividing the motion picture with [Video Divide] (P97).
> Image cannot be transmitted when the battery indicator is flashing red.
•Only the motion pictures recorded in [MP4] can be transmitted.
• Is the size of the image too large?
> Transmit after dividing the motion picture with [Video Divide] (P97).
The image that was supposed to have uploaded to the WEB service is not there.
I would like to return the image in the WEB service to the camera.
I cannot display or delete the images uploaded to the WEB service by this unit.
Your “LUMIX CLUB” login ID and password were deleted after sending the camera in
to be repaired.
There is an image that could not be transmitted.
I have forgotten the password for the Wi-Fi.
Transmission of the image fails midway.
Motion picture cannot be transmitted.