Filter
Top Products
4. Fax
33
4.4.2 Adding a new item into the broadcast
memory
After initial programming, you can add new items (up to
a combined total of 20).
1 Press {>}.
L Confirm that there are no documents in the
document entrance.
2 Press {A} or {B} repeatedly to display the desired
broadcast memory (“<BROADCAST1>”,
“<BROADCAST2>” or “<MANUAL BROAD>”).
3 Press {Menu}.
4 Press {*}.
5 Press {A} or {B} repeatedly to display the desired
item you want to add.
6 Press {Set}.
L To add other items, repeat steps 5 and 6 (up to
20 items).
7 Press {Stop} to exit.
Note:
L When adding new items to the MANUAL
BROADCAST memory, you can only select stored
items.
4.4.3 Erasing a stored item from the
broadcast memory
1
Press {>}.
L Confirm that there are no documents in the
document entrance.
2 Press {A} or {B} repeatedly to display the desired
broadcast memory (“<BROADCAST1>”,
“<BROADCAST2>” or “<MANUAL BROAD>”).
3 Press {Menu}.
4 Press {#}.
5 Press {A} or {B} repeatedly to display the desired
item you want to erase.
L To cancel erasing, press {Stop}.
6 Press {Set}.
7 Press {Set}.
L To erase other items, repeat steps 5 to 7.
8 Press {Stop} to exit.
4.4.4 Sending the same document to pre-
programmed parties
1
Insert the document FACE DOWN.
2 If necessary, press {A} or {B} repeatedly to select
the desired resolution (page 30).
3 Press the desired {Broadcast} (1-2) or {Manual
Broad}.
L After transmission, the unit will automatically
print a report (broadcast sending report).
Note:
L If you select “FINE”, “SUPER FINE”, “PHOTO” or
“MIXED” resolution, the number of pages that the
unit can send will decrease.
L If the document exceeds the memory capacity,
sending will be canceled.
L If a party is busy or does not answer, it will be skipped
and redialed later 1 time.
To cancel broadcast transmission
1. Press {Stop} repeatedly until “SEND CANCELED?”
is displayed.
2. Press {Set}.
FL421-PNQX3022ZA-OI-en.book Page 33 Thursday, July 29, 2010 9:35 AM