Filter
Top Products
140
Close all applications
and turn off the
computer, then turn it
on again.
An illegal error has
occurred.
KX-P8410 or Printer Driver
is in error. Abort printing.
Error message Possible cause Recovery
Care and Maintenance
Reinstall the KX-P8410
software.
1/16 compression table
is not found.
Check the cable
connection of the
printer or turn on the
printer.
The printer connected
with the parallel cable
is not recognized.
Block 16 table open error:
Table file not open!
BReprint later when
the printer is free
from other jobs.
The printer is printing.
KX-P8410 is not detected.
Selected port is LPT.
Please check LPT cable,
Power ON or Printer
condition.
The printer is being
used by another
device.
KX-P8410 is already used
by other devices.
BReprint later when
the printer is free
from other jobs.
BTurn off the printer
and the computer,
then turn them on
again.
KX-P8410 is not detected.
Selected port is SCSI.
Please check SCSI cable,
Power ON or Printer
condition
KX-P8410 is not
recognized as a SCSI
device.
Check the cable
connection of the
system or turn on the
printer.
BConfirm the SCSI
board is correctly
installed in the
computer or cable is
correctly connected.
BTurn off the
computer, then turn it
on again.
LPT Port or KX-P8410 is
busy.
Printer Driver For Windows 3.1
ASPI does not support this
mode!!
Correctly install the
SCSI board and its
driver. (Refer to the
manual of the SCSI
board.)
For any other trouble
related to SCSI, refer to
the SCSI section of
Care and Maintenance
( ☞ P. 134).
ASPI is not initialized!!
SCSI board and its
driver are not installed
correctly.
The transfer data area
for printing has
allocated more than
16MB.
Memory is allocated Above
16MB. If your SCSI
controller is connected in
an ISA slot, Printing may
not print correctly!!
Resource DLL file is not
found.
The necessary file for
printing is not found.
Reinstall the KX-P8410
software.