Filter
Top Products
Chapter 1 Preparation — Precautions for use
ENGLISH - 19
f Directing a high-power laser beam onto the lens surface can damage the DLP chips.
rDo not move the projector or subject it to vibration or impact while it is operating.
Doing so may shorten the life of the built-in motor.
rLamp
The light source of the projector is a high-pressure mercury lamp.
A high-pressure mercury lamp has the following characteristics.
f The luminance of the lamp will decrease by duration of usage.
f The lamp may burst with a loud sound or have its service life shortened because of shock, chipping, or degradation due to
cumulative runtime.
f The lamp life varies greatly depending on individual differences and usage conditions. In particular, frequent on/off switching
of the power greatly deteriorate the lamp and affects the lamp life.
f Continuous use for over one week will deteriorate the lamp. The degradation of the lamp due to continuous use can be
reduced by using the [PROJECTOR SETUP] menu → [LAMP RELAY].
f In rare cases, the lamps burst shortly after projection starts.
f The risk of bursting increases when the lamp is used beyond its replacement cycle. Make sure to replace the lamp unit
regularly.
(“When to replace the lamp unit” (x page 160), “How to replace the lamp unit” (x page 161))
f If the lamp bursts, gas contained inside of the lamp is released in the form of smoke.
f It is recommended that you store the Replacement lamp unit as a contingency.
rComputer and external device connections
f When connecting a computer or an external device, read this manual carefully regarding the use of power cords and
shielded cables as well.
f Use a commercial cable with a ferrite core for connecting with the <DVI-D IN> terminal.
rViewing 3D images
(Only for PT-DZ13KU, PT-DS12KU, PT-DW11KU)
The projector can display 3D video signals that are input through various systems such as “frame packing” and “side by side”.
You are required to prepare external devices for viewing 3D images (such as 3D eyewear, video signal output devices) which
are suitable for your 3D system. For connections of the projector and external devices, they are different depends on the 3D
system to be used, see the operating instructions of external devices you use.
Refer to “List of 3D compatible signals” (x page 177) for the types of 3D video signals that can be used with the projector.
Software information regarding this product
© Panasonic Corporation 2013
This product is equipped with the following software:
(1) Software which is developed independently by or for Panasonic Corporation
(2) Software which is licensed under GNU GENERAL PUBLIC LICENSE
(3) Software which is licensed under GNU LESSER GENERAL PUBLIC LICENSE
For license conditions related to software in (2) and (3), refer to the provisions of the software licenses (GNU GENERAL
PUBLIC LICENSE and GNU LESSER GENERAL PUBLIC LICENSE) in the supplied CD-ROM. (Those provisions are written
in English because they have been stipulated by third parties.)
If you have any questions regarding the software, please contact us via email (sav.pj.gpl.pavc@ml.jp.panasonic.com).