Filter
Top Products
<System format selection for S-VIDEO (VIDEO) input signals>
If S-VIDEO or VIDEO has been selected as the input signal source, there may be times where the signal format is
not selected correctly, with the result that a normal picture is not projected. If this happens, select the correct signal
format by the following procedure. The default setting is “AUTO”.
Setting procedure
1. Press the MENU button to display the MENU screen.
2. Press the “ ” and “ ” buttons to select “PICTURE”.
3. Press the “<” and “>” buttons to display the PICTURE screen.
4. Press the “ ” and
“ ” buttons to select “TV-SYSTEM”.
5. Press the “<” and “>” buttons to select either “AUTO”, “NTSC”, “PAL”, “SECAM”
or “NTSC 4.43”.
Select the appropriate signal format for the input signal while referring to the table below.
Horizontal scanning frequency [kHz]
Vertical scanning frequency [Hz]
Color subcarrier frequency [MHz]
AUTO
Automatically selects NTSC, PAL, SECAM or NTSC 4.43.
NTSC
NTSC 4.43
15.7
60.00
3.58
4.43
PAL
SECAM
15.63 50.00
4.43
4.25 or 4.41
NOTE:
The correct signal format may not be selected if, for instance, you are using a poor-quality signal source, such as
a dubbed video tape. Switching the signal format may give better results in such cases.
The setting screen and the MENU screen can both be cleared by pressing the MENU button.
Adjusting the volume
The volume can be adjusted by pressing the VOL (+/-) buttons on the remote control unit.
Remote control unit
If the “+” button is pressed, the volume will increase,
and if the "-" button is pressed, the volume will
decrease.
NOTE:
If these buttons are pressed while the on-screen display
for another function is currently on the screen, the
volume will still be adjusted but the current volume
setting and the volume bar display will not appear.
The volume can also be adjusted from an on-screen
display menu. Refer to page 24 for details on how to do
this.
The volume output level will remain displayed on the
screen for approximately three seconds.
-20-