Filter
Top Products
Turning off the sound
If the MUTE button on the remote control unit is pressed, “MUTE” will be displayed on the screen as shown in the
illustration below and the sound will be muted. If the MUTE button is pressed once more, the on-screen display will
be cleared and the normal sound volume will be restored. The volume output level will remain displayed on the
screen for approximately three seconds.
Remote control unit
NOTE:
If the MUTE button is pressed while the on-screen display
for another function is currently on the screen, the volume
will still be muted but the “MUTE” on-screen display will not
appear.
If the power supply is turned off or either of the VOL (+/-)
buttons is pressed, the mute setting will be canceled.
It is also possible to have the picture turn off together with
the sound when the MUTE button is pressed. Refer to page
32 for details on how to change this setting.
When the picture has been turned off in this way, the words
“PICTURE MUTE” will be displayed on the screen.
Displaying the on-screen menu
The menu screen can be displayed by pressing the MENU button on the projector control panel or the remote
control unit.
Projector
Remote control unit
If the MENU button is pressed when there is
not already an on-screen display, the MENU
screen shown at left will be displayed.
NOTE:
or
If the MENU button is pressed while an
on-screen display is already appearing,
the on-screen display will return to the
previously-displayed screen each time
the MENU button is pressed. If it is
pressed while the MENU screen shown at
left is being displayed, the MENU screen
will be cleared.
Resetting adjustment values to the factory pre-settings (standard values)
If the STD (Standard) button on the remote control unit is pressed while the PICTURE screen, POSITION screen,
AUDIO screen or one of the individual adjustment screens is being displayed, the adjustment settings being
displayed will be reset to the factory pre-settings.
Remote control unit
If the STD (Standard) button on the remote control unit is
pressed while the PICTURE screen, POSITION screen or
AUDIO screen is being displayed, the letters “STD” will be
displayed in yellow in the top-right corner of the screen and
all items displayed will be reset to the factory pre-settings.
NOTE:
However, the “TV-SYSTEM” and “SIGNAL MODE” settings
in the PICTURE screen and the “VOLUME” setting in the
AUDIO screen will not return to the factory pre-settings.
If the STD (Standard) button on the remote control unit is
pressed while one of the individual adjustment screens is
being displayed, the value and the bar display will be
appeared in yellow and only the item displayed will be reset
to the factory pre-setting.
-21-