Filter
Top Products
Adjusting the picture to the desired setting
You can adjust the picture settings for any of the input signal sources selected according to the procedure on page 18.
The items which can be adjusted vary depending on the type of input signal. The adjustment procedure below
describes the on-screen displays when a signal is being input to the S-VIDEO IN terminal or the VIDEO IN terminal.
Adjustment procedure <for the COLOR setting>
1. Press the MENU button to display the MENU screen.
2. Press the “ ” and
“ ” buttons to select “PICTURE”.
3. Press the "<" and “>” buttons to display the PICTURE screen.
4. Press the " " and
" " buttons to select “COLOR”.
NOTE:
If the STD (Standard) button is pressed while the PICTURE screen at right is
being displayed, the letters “STD” will be displayed in yellow in the top-right
corner of the screen and all settings other than the TV-SYSTEM setting will be
reset to the factory pre-settings. Furthermore, the values and bar displays for
items which have returned to the factory pre-settings will be displayed in yellow.
5. Press the "<" and ">" buttons to display the COLOR individual adjustment screen.
6. Continue pressing the “<” and ">" buttons to adjust the color. The current setting
will be displayed on the screen by numerals and a bar.
The adjustment operation and the changes made will vary depending on which
adjustment item is selected. Refer to the table below for details.
Adjustment Item
COLOR
TINT
BRIGHT
CONTRAST
SHARPNESS
NOTE:
Adjustment function display
Numeric adjustment level display
Bar display
Button
Adjustment Details
Adjustment Range
Remarks
Press the ">" button.
The color becomes darker.
Max. value 63
Press the “<” button.
The color becomes lighter.
Min. value 0
S-VIDEO/VIDEO only
Press the “>” button. Flesh tones become greenish.
Max. value 63
NTSC, NTSC 4.43 (S-
Press the “<” button.
Flesh tones become reddish.
Min. value 0
VIDEO/VIDEO)only
Press the “>” button.
The screen becomes brighter.
Max. value 63
Press the “<” button. The screen becomes darker. Min. value 0
Press the ">" button.
The screen becomes brighter
and the picture becomes darker.
Max. value 63
Press the “<” button.
The screen becomes darker and
Min value 0
the picture becomes lighter.
Press the “>” button.
The picture quality becomes sharper.
Max. value 63
Press the “<” button.
The picture quality becomes softer.
Min. value 0
S-VIDEO/VIDEO only
If approximately five seconds pass without any buttons being pressed while an individual adjustment screen is
being displayed, the display will return to the PICTURE screen.
Press the MENU button to return to the PICTURE screen or to clear the MENU screen.
If the STD (Standard) button is pressed while one of the individual adjustment screens is being displayed, the
value and the bar display will be appeared in yellow and only the item displayed will be reset to the factory pre-
setting.
Refer to page 20 for details on the TV-SYSTEM setting which is displayed in the PICTURE screen, and to the
following page for details on the W-BAL R/G/B setting which is displayed when RGB signals are being input.
Furthermore, refer to page 19 for details on the SIGNAL MODE setting when RGB signals are being input.
If a PAL or SECAM signal is being input, the TINT item will not appear on the screen.
-22-