<
Back, bottom and right view
>
Lamp unit cover
(page 42)
Remove this cover to get access
to the lamp unit.
Fixing screw for the lamp
unit cover
(page 42)
Remove this screw when
replacing the lamp unit.
Adjuster button
(page 15)
This button is used to
unlock the adjustable legs.
Remote control signal receptor
(page 10)
This receives the infrared signal transmissions from the
remote control unit.
Front
Fixed legs
Adjustable legs (two)
(page 15)
These legs can be used to adjust
the angle of inclination of the
projector.
<Side terminal board>
VIDEO IN terminal
(page 33)
This terminal is used to input
composite video signals.
S-VIDEO IN terminal
(page 33)
This terminal is used to input S-
VIDEO signals.
RGB 2 (RGB IN/AUDIO
IN) connector/terminal
(page 34)
This connector and terminal
are used to input RGB
signals and the audio signal
which accompany them.
RGB 1 (RGB IN/AUDIO IN)
connector /terminal
(page 34)
This connector and terminal are used
to input RGB signals and the audio
signal which accompany them.
Air filter
AUDIO IN (L-R) terminals for S-VIDEO/VIDEO
input
(page 33)
These terminals are used to input audio signals
which correspond to the signals input to the
VIDEO IN or S-VIDEO IN terminal.
AUDIO OUT terminal
(pages 33 and 34)
This terminal is used to output
audio signals which are input
from the AUDIO IN terminal for
RGB input or the AUDIO IN (L-R)
terminals for S-VIDEO/VIDEO
input. The sound output is
automatically switched when
the audio input source is
switched.
SERIAL connector
(page 36)
This connector is used to con-
nect a personal computer to
the projector in order to exter-
nally control the projector.
MOUSE connector
(pages 34 and 35)
This connector is used to connect an accessory
or separate mouse cable. This lets you operate a
personal computer using the pointer button and
click buttons on the remote control unit instead of
using a mouse.
-8-