Panasonic PT-L592U Projector User Manual


 
Example of connection to a computer
Computer
Pin configuration and signal names for RGB connector
Pin No.
Signal name
5
1
1
R
2
G/G.SYNC
10
6
3
B
15
11
9NC
NOTE:
12
SDA
Pin No.
12 and
pin
13
HD/SYNC
Audio system
No. 15 on 15-pin
14
VD
connectors will
15
SCL
only work if the
4-8,10, and 11
GND
computer supports
them.
Computer for
control use
To audio
output
terminal
To video
output
connector
RGB signal conversion adapter for
Macintosh (sold separately)
D-SUB 9-pin
(female)
D-SUB 15-pin
(male)
D-SUB 15-pin
(male)
RGB signal cable
(supplied as an
accessory)
13-pin (male)
Mouse cable for PS/2
(supplied as an accessory)
Computer
To mouse connector
To audio output terminal
To video output connector
NOTE:
If the mouse connector on the projector is connected to the mouse connector on the computer with the
accessory or separate mouse cable, you can then use the remote control unit in place of the computer’s mouse.
However, this function operates only when input to the RGB 1 connector has been selected. For further details,
refer to page 35.
If you wish to use the infrared mouse function, turn on the main power to the projector before turning on the
personal computer.
If using a personal computer with a suspend/resume function, the infrared mouse function may not operate until
the computer is restarted.
Refer to the data on page 19 for details of what kinds of computers can be connected to the projector. If
computers other than those listed here are used, correct operation cannot be guaranteed.
-34-