Panasonic PT-L592U Projector User Manual


 
Using the serial connector
The serial connector which is on the side terminal board of the projector conforms to the RS-232C interface
specification, so that the projector can be controlled by a personal computer which is connected to this connector.
<Side terminal board>
SERIAL
Computer
D-SUB 9-pin
NOTE:
Communication cable
Use a proper communication cable which is suitable for the personal computer to connect the serial connector
and the personal computer.
Pin layout and signal names for SERIAL connector
Projector
Pin No.
Signal name
Contents
NC
D-SUB 9-pin connector
(male) seen from the
outside
RXD
TXD
GND
RTS
CTS
Received data
Transmitted data
NC
GND
NC
Connected internally
NC
Communication settings
Signal level
Synchronizing method
Baud rate
Parity
Character length
Stop bit
X parameter
S parameter
Determined by the RS-232C interface
Asynchronous
9600 bps
None
8 bits
1 bit
None
None
Basic format
Each packet which is sent from the computer starts with STX. Following this is the command itself and the
parameters for that command (if any), and the packet then ends with ETX. Add parameters when necessary
according to the control contents.
STX
C1 C2 C3 : P1 P2 P3 P4 P5
ETX
Parameter (1-5 bytes)
Colon (1 byte)
Start byte
Command (3 bytes)
NOTE:
If sending multiple commands, check that a response has been received from the projector for one command
before sending the next command.
If an incorrect command is sent from the personal computer, the “ER401” command will be sent from the
projector to the personal computer.
-36-