Filter
Top Products
6-3
Problems?
Tape Feeding Problems
Improper Loading (DM300 only)
Load tape strips print side up and guide them all the way into the feeder—push
them in as far as they’ll go.
HINT: Always remove remaining tape strips before you add a new stack.
Tape or Paper Fragments in Feeder (DM300 only)
Clean tape strip feeder:
1. Remove the moistener (see
page 5-1).
2. Slide the tape strip feeder cover to
the left and remove.
3. Remove the tapes. Inspect the feeder
and clean out any debris. Push down
on the spring-loaded pressure plate
and remove any paper from under
the feed roller or tape guide.
4. Slide the tape strip feeder cover back
into position.
5. Reinstall the moistener (see page
5-3).
6. Load tape strips and resume normal
operation.
Slide cover to left
Pressure
plate
Tape guide
Feed roller