Filter
Top Products
42 J693
Three Media Sensor readings are required:
Empty: Nothing in the sensor.
Mark or Gap: Only the backing material, notch, or reflective mark in the sensor.
Paper: The label (with the backing material attached) in the sensor.
To perform a Standard Calibration:
Step Operator Action Displayed Message Comment
1
Turn ‘On’ the printer.
Wait until
‘Ready’ is
displayed.
2
Press the
key to enter
Menu Mode.
Raise the printhead for
visual access to the Media
Sensor and load label
media.
See Section
4.0.2 for
details.
3
Press the key to
enter the Media Settings
menu.
See Section
4.1.1 for
details.
4
Press the key.
See Section
4.1.1 for
details.
5
Press the key. Use
the key to scroll
to the desired sensor type
and press the
key
to enable the selection.
See Section
4.1.1 for
details.
The enabled
selection will
be indicated
with an *
.
(Continued next page)