Filter
Top Products
J693 61
5.6.2 Updating from the Download Mode
Required Update Procedure for Application Version 2.08 or earlier*
Step Displayed Message Operator Action Comment(s)
1.
Press and hold the
PAUSE and TEST
keys while turning
‘On’ the printer to
enter the Download
Mode.
The Boot Loader version
is displayed.
Note: This information
will vary with the printer
model and Boot Loader
version.
2.
Using the DOS
copy command,
copy the filename
to the printer (see
Step 2 in Section
5.6.1).
The printer is ready to
accept the new application
version.
Note: The parallel port
(LPT1) must be used to
write to the printer.
3.
No action required. The printer is receiving
the new image (program).
4.
No action required. The program has been
received and verified; now
Flash memory is cleared
of the previous
application.
5.
No action required. The new program is being
written into Flash memory.
Upon completion, the
printer will automatically
reset, starting the new
application; however,
before continuing, the
printer must be re-
calibrated; see Section 5.2.
*This can also be used as an alternate download method for all other version levels.