Filter
Top Products
J693 73
Warning Messages:
Displayed Message Description Action
The printer has
detected burned-
out printhead
elements.
Replace the printhead when
print quality becomes
unacceptable or if the
printed bar codes are non-
compliant.
The printer missed
detecting a label
gap.
Readjust the media sensor
and recalibrate.
Power has been
removed and
shutdown is in
progress.
The printer power switch
was turned ‘Off’, the line
fuse has blown, or AC line
voltage has been lost.
The host has
pending
configuration
changes that will
not take effect until
a ‘host reset
command’ is
issued.
To save changes, send a
host reset command (in
DPL) or to discard changes
perform a front panel reset;
see Section 4.0.6.
The printer has
detected a low
operating voltage.
A possible low or
fluctuating line voltage
level. Try moving the
printer to another outlet. If
this condition persists call
for service.
Ribbon will soon
need replacement.
Replace ribbon when
needed.
The printer was
unable to save
settings in
permanent
memory.
If the condition persists,
possible faulty Main PCB.
Call for service.
(Continued next page)