Planet Technology IDL-2400 Network Card User Manual


 
IP DSLAM
289
Type: Modify -- Optional
Valid values: 0 - 310
atucconfpml2minrate
<atucconfpml2minrate-val>
PM configuration parameter, related to the L2 low power state. This
parameter specifies the minimum net data rate during the low power
state (L2). The data rate is coded in bit/s, and can range from 0x1F40
(8000) bps to 0xFA000 (1024000) bps.
Type: Modify -- Optional
Valid values: 0x1F40 - 0xFA000
atucconfmsgminds
<atucconfmsgminds-val>
Configures downstream overhead channel bandwidth. This feature is
not supported by DSLPHY as yet.
Type: Modify -- Optional
Valid values: 4000 - 64000
aturconfmsgminus
<aturconfmsgminus-val>
Configures upstream overhead channel bandwidth.This feature is not
supported by DSLPHY as yet.
Type: Modify -- Optional
Valid values: 4000 - 64000
atucminsnrmgn
<atucminsnrmgn-val>
Atuc Configured Minimum Signal/Noise Margin. This is the Noise
Margin, the modem must achieve with a BER of 10 to the power -7 or
better, to successfully complete initialization. The default value
mentioned is an indicative value only.
Type: Modify -- Optional
Valid values: 0 - 310
aturminsnrmgn
<aturminsnrmgn-val>
Atuc Configured Minimum Signal/Noise Margin. This is the Noise
Margin, the modem must achieve with a BER of 10 to the power -7 or
better, to successfully complete initialization. The default value
mentioned is an indicative value only.
Type: Modify -- Optional
Valid values: 0 - 310
atucfrontenddesigntype
El1508 | El1528 | Le87213
Front end hardware reference design
Type: Modify -- Optional
atuchwpwrreduction Disable
| Enable
Hardware configuration parameter
Type: Modify -- Optional
atucgsusbitswap Disable |
Enable
This parameter enables/disables upstream bit swapping
Type: Modify -- Optional
aturmaxsnrmgn
<aturmaxsnrmgn-val>
Configured Maximum acceptable downstream Signal/Noise Margin. If
the Noise Margin is above this the modem attempts to reduce its power
output to optimize its operation. The value set by the user is in dB/10,
and ranges from 0 to 31 dB in 1 dB steps.
Type: Modify -- Optional
Valid values: 0 - 310