Filter
Top Products
IP DSLAM
329
Parameters:
Name Description
ifname<interface-name
>
This parameter specifies the name assigned to this interface.
Type: Create － Mandatory
Delete － Mandatory
Get － Optional
Modify － Mandatory
Valid values: eoa-0,eoa-1….
lowif
<low-interface-name>
This parameter specifies the lower interface index. It contains ifindex of
the AAL5 or VC Aggregation interface.
Type: Mandatory
Valid Values : aal5-0 - *
pkttype {multicast
|broadcast
|unknownunicast}+ |
all|none
This parameter defines the packet type supported by the interface.
‘EoAPktTypeSupported’ shall be configured for every CPE side
Ethernet interface. By default, the option taken is 'ALL' and it means that
all packets will be transmitted. The value 'None' means that normal
Ucast packets will be transmitted. The interface shall not transmit any
other packet type than the ones configured.
Type: Optional.
Valid Values: {multicast |broadcast |unknown-unicast}+ | all
Default Value: all.
fcs false | true
This specifies whether Ethernet FCS needs to be computed for the CPE
side Ethernet interfaces. This can be set to true only if encaptype of the
lower interface is Ethernet.
Type: Optional
Valid Values: false or true
Default Value: false.
Enable|disable
Administrative status of the interface
Type: Optional
Valid values : enable or disable
Default Values: enable
inactivitytmrintrvl
<inactivitytmrintrvl-val>
This field specifies the time (in seconds) after which interfaces shall be
marked inactive if there is no data activity on this interface during this
interval. This is used only when the bit corresponding to "ConfigEntry" is
set for gsvEoaConfigStatus field. A value of zero means the timer is not
running. In Aautosensing scenario, an inactive interface is a candidate
to deletion in case another protocol is sensed on Atm Vc Interface on
which this interface is created.
Type: Optional
Valid Values: 0 to 0xffffffff