Filter
Top Products
IDL series User Guide
362
5.13.13.2 Modify clfr tree node
Description:
Use this command to get.
Command Syntax:
modify clfr tree node tname <tname-val>pid <pid-val>nodeid <nodeid-val>
[ descr <descry-val> ] [ offset <offset-val> ] [ mask <mask-val> ] [ value
<value-val> ] [act Drop|Fwd|FwdToCtl|CpToCtl|Eq|Gt|Lt|InRange |TerCmp|
SetPrio|MatchInList|AccDeny|SetBase|Count| Retagprio |
MatchIngenlist|GoToNextRule| allow] [valend valend ] [sbasetype Abs | Add |
Compute] [ shiftcnt <shiftcnt-val> ] [ mplr <mplr-val> ] [valtype
U8|U16|U32|U64|AtmIf|Aal5Vc|EoaIf|EthIf|Dir|Prio|Len|vlanid][ sbvarindex
l2start|l3start ] [nodeprio low]
Parameter:
Name Description
tname tname
Name of the classifier tree
Type: Modify -- Mandatory
Get -- Optional
Default value: -----
pid pid
Profile Id. It should be unique within a tree.
Type: Modify -- Mandatory
Get -- Optional
Valid values: 1 - 0xffffffff
Default value: -----
nodeid nodeid
Node Id, should be unique within a profile
Type: Modify -- Mandatory
Get -- Optional
Valid values: 1 - 0xffffffff
Default value: -----
descr descr
Description of the tree node. If the ActVal is FwdToCtl or CpToCtl
then this field is mandatory and it can be used by the applications to
receive the packets coming from control plane because of this node.
Type: Modify -- Optional
Default value: -----
offset offset
OffSet, in the packet with respect to the base offset, from where we
have to take the value, which is to be matched. If ActVal is SetBase
and SBaseType is Compute then this value is used to specify the
offset with respect to the base offset, which shall be used to specify
the field of the packet used to compute the new base offset. If the