Filter
Top Products
12 Load Label Stock
This section details the general process for installing label stock on the unwinder, and attaching the
label stock to the rewinder.
1. Switch on the unwinder, printer and rewinder.
2. Place the label stock roll (max 12" OD) on the unwinder chuck. Push the stock all the way back
until it touches the stop disc.
Section 4: Load Label Stock
I
O
Figure 4-1.
Stop Disc
Figure 4-2.
Note: You must use only 8.5 inch wide label stock in the CX1200. Failure to use specified label stock
will result in damage to your printer and excessive build up of toner and adhesive inside the printer.
Caution! You can not use die cut label stock in the CX1200. The extreme heat produced by the fuser
will cause the die cut labels to peel off the label backing and get jammed inside the printer. Also, the
printer is not designed to line up print images with the specific locations of the die cut labels.
TOC
INDEX