Filter
Top Products
Maintenance and Troubleshooting 49
4. The following calibration print will print to the Printer.
5. Measure the lines on the calibration print. Enter the letter below the line which measures
closest to 10.00 inches. (Each line differs in length by .01 inch)
6. Click Set.
In most cases, performing this calibration once will be sufficient. However, it may be necessary to
run the calibration again if the fuser is replaced.
A B C D E F G H I
Measure the lines to the left.
Circle the letter below
the line which measures
closest to 10.00 inches.
(Each line differs in length by .01 inch)
Stretch Factor
Calibration Print
J K L M N
O
Tip: Use a clear acrylic
ruler to measure the lines.
TOC
INDEX