Filter
Top Products
Load Label Stock 15
7. Print your label according to Section 5 of the manual.
Note: Depending on when the printer was last used, the fuser will need to heat up or cool down before
the printer will print. This can take from 2 seconds to 2 minutes.
8. Attach the label stock to the rewinder core.
A. As the printer is preparing to print, get a piece of tape ready. It is best to stand to the right
side of printer with your arms above the rewinder roll. As the stock is ejected from the
printer guide it with your left hand through the tensioner unit. As soon as it clears the
tensioner place the tape on the middle of the end of the stock.
Note: Make sure the stock feeds under the rollers inside the tensioning unit. If possible use your
left had to guide the stock under the roller as it exits the printer.
B. The stock will continue to feed at a slower speed. When it reaches the rewinder, attach it to
the top of the empty label core. Position the stock so that it that it is centered on the core.
Figure 4-7.
Figure 4-8.
TOC
INDEX