Filter
Top Products
2–4 Setting Up the Printer
Select a Site
When selecting the location for the printer, consider the following power
requirements, interface requirements, and environmental factors:
• A proper power source must be available. (Complete power requirements
are specified in the “Check Power Requirements” section on page 2–3.)
• The location must be within the maximum cable length specifications for
the host computer interface.
• The temperature range should be +50°F to +90°F, with no sudden
changes in temperature or humidity. The printer should be positioned
away from any air drafts from heating or air conditioning ducts.
• Insure that the room provides adequate ventilation. The minimum room
volume is 1000 cubic feet and must provide, at a minimum, one fresh air
exchange every two hours.
• The location should provide enough space for maintenance and
replacement of consumables (toner, developer, paper, etc.). Refer to
Figure 2–1.
• The printer should not be exposed to direct sunlight or hot lighting
equipment. This may cause an abnormal temperature rise in the printer
and adversely affect its operation. If necessary, shade or screen the
printer from such exposure.
• Avoid exposing the printer to any corrosive gases or vapors.
• Avoid installing the printer in an area subject to heavy vibrations.
For additional environmental requirements, refer to the Introduction chapter and
to Appendix A.
Figure 2–1 illustrates spatial site requirements for the printer. The dimensions are
listed in inches and include the requirements with the top and front covers open.
NOTE: The actual printer dimensions are shown in Figure 2–1. When
installing the printer at your site, allow an additional 6 inches
clearance behind the printer for connection of interface and power
cables.