Filter
Top Products
3–18 Configuring the Printer
Image Width
This option specifies the width of the image to be printed. The allowable range is
0.5 to 8.2 inches. The factory default value is 8.2 inches.
NOTE: If the paper width is less than 8.2 inches, you must set this
parameter for proper positioning of the image on the paper.
Paper Length
This option specifies the vertical perf–to–perf distance of the continuous–form
paper (i.e., the physical form length). The paper length may be specified in three
different units:
Inches: 3.0 to 33.0 inches, in 1/2–inch increments (default: 11”)
6 LPI: 6 to 198 lines, in 1–line increments (default: 66 lines)
8 LPI: 8 to 264 lines, in 1–line increments (default: 88 lines)
The printer can move paper in 1/6 or 1/8 inch increments. Therefore, the printer
will always move paper the exact distance specified from this option.
Horizontal Image Shift
This option specifies the amount to shift an image to the right for precise
positioning on the page. The actual width of the image is not affected by this
parameter. The allowable range is 0.0 to 1.0 inch, in 1/20–inch increments. The
factory default is 3/20 inch.
Vertical Image Shift
This option specifies the amount to shift an image down for precise positioning
on the page. The actual length of the image is not affected by this parameter. The
allowable range is 0.0 to 1.0 inch, in 1/100–inch increments. The factory default
is 0/100 inch.
Reprint on Fault
The printer stops processing of a print image when the printer experiences a fault
condition. Enable the reprint on fault option so the printer will process the entire
image page that was being printed when the fault occurred. This option verifies
that a printer fault will not interfere with the printing of an entire document.