Filter
Top Products
3–7Configuring the Printer
Saving a Configuration
You can save up to eight different configurations to meet unique print job
requirements.
For example:
Config. 0: Factory Default (This cannot be altered. See page 3–14.)
Config. 1: Selects RS–232 Serial Interface
Selects Image Width of 4 inches
Selects Paper Length of 24 inches
Selects Image Shift of 1 inch, etc.
Config. 2: Selects Dataproducts Parallel Interface
Selects Image Width of 8 inches
Selects Paper Length of 11 inches
Selects Image Shift of 3/20 inch, etc.
The configurations are saved and stored on diskette for later use. These
configurations, including the factory default, will not be affected when the printer
power is turned off. If you do not save your configuration before you turn off the
printer, the current configuration will be lost.
NOTE: If the “Protect Configs.” option is enabled, the new configuration
will not be saved unless the existing configuration has been deleted.
Refer to page 3–25 for details.
Follow these steps to save a new configuration:
1. Press ON LINE to take the printer offline.
OFFLINE
PAPER CONTROL
2. Press NEXT or PREV until the following is displayed:
OFFLINE
DISK MANAGEMENT
3. Press DOWN.