Filter
Top Products
2–11Setting Up the Printer
Add the Starter Toner
IMPORTANT
For the initial installation, use the starter toner bottle from the
developer kit. Do not use the toner bottles in the toner kit, which consists
of two toner bottles, two fuser cleaner felts, and two waste toner
containers.
After adding the starter toner, do not add toner from the toner kit until
the printer displays a toner low message. Starter toner will provide
approximately 200 pages of print at 5%.
Toner is light and easily becomes air–borne and can contaminate the printer. Be
careful not to stain your hands, clothes, or the interior of the printer with toner.
NOTE: If toner is spilled, use a toner vacuum to clean up the loose toner.
Do not use water to clean the toner from the printer. Any toner
remaining on clothes can be removed with a cloth dampened in cold
water. Never use hot water to remove toner from clothes or skin.
Use care when handling toner.
When the toner is low, the printer will stop and the LCD will show “03 ADD
TONER AND CHK WASTE BOTTLE.”
NOTE: Do not turn off the printer during a print job to add toner; otherwise,
all unprinted data will be lost. Once the toner is added, press ON
LINE to continue printing.
Refer to Figure 2–6 and perform these steps:
1. Open the starter toner bottle from the developer kit, and attach the
spout.
2. Carefully open the developer unit cover.
3. Carefully pour the starter toner into the developer unit. Make sure to
spread the toner evenly from side to side.