Filter
Top Products
3–11Configuring the Printer
g. When the desired number is displayed, press ENTER to make
the selection. The JOB IN PROCESS light flashes and the
following is displayed briefly:
STANDBY
. . .
The following is displayed to indicate the configuration is being
loaded:
Load Config.
(selected number) *
2. Move through the menu and change all the desired values. (In this
example, you would change the interface type value from Serial to
Centronics.)
3. Press ENTER to save each new value. An asterisk is displayed next to
the selected value.
4. Before saving the modified configuration, you must delete the original.
a. Press ON LINE to take the printer offline.
OFFLINE
PAPER CONTROL
b. Press NEXT or PREV until the following is displayed:
OFFLINE
DISK MANAGEMENT
c. Press DOWN.
d. Press NEXT or PREV until the following is displayed:
DISK MANAGEMENT
Delete Config.