Filter
Top Products
Admin User Menu Items
33
Certain tag types are designed to allow early tag writing for
maximum print speed. The default is 0.00 inches.
IMPORTANT
Change this menu item with caution. If the write is performed
too early, the wrong tag will be written.
Custom Run Cal
This menu item causes the printer to run calibration for the current
RFID tags installed in the printer. After the calibration is complete,
the custom settings are changed to work with the tags installed.
These settings do not take effect until Custom Tag is set to Enable.
Custom Tag Pos
This menu item determines how far the RFID tag position of the
currently installed custom tags differs from the RFID tag position of
the standard Printronix tag. Printronix printers print at maximum
speed with RFID labels that have RFID tags in the standard
position. The default is 0.0 inches.
Custom Start Pos
This menu item determines where on the label the RFID calibration
will begin. By default, the calibration procedure will start at the
beginning of the label (0.0 inches). To make the calibration work
faster, change this value to force the calibration to begin after the
beginning of the label.
Custom Scan Len
The menu item determines how much of the label will be scanned
during the RFID calibration procedure. The default is 3.0 inches.
Custom Min Power
The menu item determines the minimum power level that the
calibration procedure will use when attempting to find the ideal
power level. To make the calibration work faster, increase this
value to exclude the lower power levels. The default is 1.