Filter
Top Products
Chapter 2 RFID PPI/ZGL Commands
60
b
Sets the read/write position of the
transponder in the vertical (Y axis) in dot
rows from the top of the label. Set to 0 if
the transponder is already in the effective
area without moving the media. The
default value is label length minus 1 mm.
The acceptable value range is 0 to label
length.
c
Sets the length of the void printout in dot
rows. The acceptable value range is 0 to
label length. (This option is currently not
supported.)
d
Sets the number of retries that will be
attempted in case of read/write failure. The
number will reflect in the Label Retry
menu.
e
Error handling. Enter N for no action. Enter
P to place the printer in Pause mode. Enter
E to place the printer in Error mode. (This
option is currently not supported.)
f
Signals on applicator. Enter S to single
signal. Enter D for double signal. (This
option is currently not supported.)
g
Certify tag with a pre-read. (This option is
currently not supported.)
h
Sets the print speed at which “VOID” will
be printed across the label. (This option is
currently not supported.)
Set RFID Tag Password
Purpose This command defines the password for the tag during
writing.
Format ^RZ
a
^RZ Set RFID Tag Password command.
a
The default is 00. The acceptable value
range is 00 to FF (hexadecimal).